How do I program my garage door remote?

Follow these step-by-step directions to program your garage door remote:

  1. Find the “Learn” button on your operator. This could be located on the back side or under one of the light covers on the operator’s head (the actual motor—not the wall station or remote). The “Learn” button will either be a small round yellow button or an approximately ½” x ½” square button that could be green, orange, or purple.
  2. Once you have located this button, simply press it. Do not hold in—just press and release like you would a doorbell.
  3. After pressing the “Learn” button, press the button on the remote that you want to use to run the door.
  4. Then try pressing the remote button again. If the remote is programmed, the door should start to move.